Ham
Centre
The Optimizer
Bar Cutting · Salon of Stock & Steel
Configuration
Project Name
i
Identifies this job. Appears at the top of the printed cut sheet / PDF.
Bar Length
i
Full length of one raw stock bar you're cutting from.
Kerf
i
Width of material removed by each saw cut (blade thickness). Added between adjacent pieces on a bar.
End Trim
i
Length cut off the start of each bar for a clean, square end before any pieces are cut. Leave 0 if not needed.
Unit
i
Measurement unit applied to all lengths in this sheet.
mm
in
cm
ft
Required Pieces
Length
Qty
＋ Add row
Clear
✦ Optimize ✦
Print · Save PDF
Bar Cut Optimization Report
◆
Enter pieces & press Optimize